Barbell Overhead Shrug
- Zielmuskel
- Trapezius Upper Fibers
- Synergistenmuskeln
- Levator Scapulae, Trapezius Middle Fibers
- Equipment
- Barbell
- Körperregion
- Back
- Typ
- Strength
The barbell overhead shrug is an upper-back and trap exercise that targets the upper fibers of the trapezius, with the levator scapulae and middle trapezius assisting. Performed with a barbell locked out overhead, you shrug the shoulders straight up to elevate the scapulae, which trains the traps in a fully overhead position and reinforces shoulder stability under load.
Barbell Overhead Shrug: So führst du sie aus
- 1Set a barbell in a rack at about shoulder height, or clean and press it overhead to start.
- 2Grip the bar slightly wider than shoulder-width with your palms facing forward and your thumbs wrapped around the bar.
- 3Press the bar up until your arms are fully locked out directly overhead, with the bar stacked over your mid-foot and your core braced.
- 4Allow your shoulders to relax slightly so your scapulae drop, letting the bar settle a touch lower while keeping your elbows straight.
- 5Shrug your shoulders straight up toward your ears, driving the bar higher by elevating your scapulae as far as they will travel.
- 6Pause briefly at the top and squeeze your upper traps without bending your elbows.
- 7Lower your shoulders back down under control to the starting depth, keeping the bar balanced overhead.
- 8Complete your reps, then carefully lower the bar to the rack or to the floor.
Technik-Tipps
- Move only at the shoulder girdle — keep your elbows locked and your spine neutral so the work stays on the upper traps.
- Use a weight you can fully control overhead, since the bar is held in an unstable position above your head.
- Brace your core and squeeze your glutes to keep the bar stacked over your mid-foot throughout the set.
- Train inside a power rack with the safety arms set high, or near a spot where you can safely ditch the bar if your balance fails.
Häufige Fehler
- Bending the elbows to press the bar instead of shrugging, which turns the movement into an overhead press and takes tension off the traps.
- Using too much weight so the bar drifts forward or back overhead, which threatens shoulder stability and your balance.
- Leaning or arching the lower back to heave the shoulders up, which loads the spine instead of the upper traps.
- Rushing the reps and bouncing at the bottom, which loses scapular control and the targeted muscle tension.
Häufig gestellte Fragen
What muscles does the barbell overhead shrug work?
It primarily works the upper fibers of the trapezius, with the levator scapulae and middle trapezius assisting as you elevate your shoulder blades. Holding the bar overhead also recruits the shoulders and core for stability.
How is the overhead shrug different from a regular barbell shrug?
A regular shrug holds the bar at your thighs and elevates the scapulae from a hanging position, while the overhead shrug holds the bar locked out above your head. The overhead version trains the upper traps in an elevated, overhead position and demands far more shoulder stability.
How wide should my grip be?
Slightly wider than shoulder-width works well, with your palms facing forward. A grip near where you would press overhead keeps the bar balanced over your mid-foot and lets you shrug straight up.
How many sets and reps should I do?
Because the bar is overhead and stability matters, keep the load moderate and aim for about 3 sets of 8 to 12 controlled reps, pausing briefly at the top of each shrug.
Is the barbell overhead shrug good for beginners?
It is better suited to lifters who already have stable overhead pressing strength, since you must hold the bar locked out the whole set. Beginners should master the overhead press and standard shrug first, then start light.
