Lever Parallel Chest Press

Cómo hacer el Lever Parallel Chest Press

1. 1Adjust the seat height so the handles are level with the middle of your chest when you sit down.
2. 2Sit upright with your back flat against the pad and your feet planted firmly on the floor.
3. 3Grasp the parallel handles with a neutral grip (palms facing each other) and position your elbows slightly below shoulder height.
4. 4Retract your shoulder blades and press them into the backpad to create a stable base.
5. 5Exhale and press the handles forward until your arms are fully extended, without locking your elbows aggressively.
6. 6Pause briefly at full extension, then inhale and slowly return the handles back toward your chest under control.
7. 7Stop just before the weight stack touches down and begin the next rep without bouncing the weight.

Consejos de técnica

• Keep your shoulder blades pulled back and down throughout the set — letting them round forward at the end of each press reduces chest activation and stresses the shoulder joint.
• Press with your chest, not just your arms. Focus on squeezing the pectorals as you push the handles forward.
• Control the return phase — lowering slowly under tension builds more muscle than rushing back to the start.
• Adjust the seat so your elbows track comfortably without dipping below the handle line, which can overload the front of the shoulder.

Errores comunes

• Setting the seat too high so the handles are above shoulder level, which shifts stress onto the shoulder joint instead of the chest.
• Pushing through a shortened range of motion by stopping the return early, which reduces time under tension for the pectorals.
• Shrugging the shoulders up toward the ears during the press, which engages the traps and takes tension off the chest.
• Using momentum by bouncing the weight stack at the bottom, which removes the eccentric load and increases injury risk.

Preguntas frecuentes